SX1231
WIRELESS & SENSING PRODUCTS
DATASHEET
5. Data Processing
5.1. Overview
5.1.1. Block Diagram
Figure below illustrates the SX1231 data processing circuit. Its role is to interface the data to/from the modulator/
demodulator and the uC access points (SPI and DIO pins). It also controls all the configuration registers.
The circuit contains several control blocks which are described in the following paragraphs.
Tx/Rx
CONTROL
DIO0
DIO1
DIO2
DIO3
DIO4
DIO5
Data
Rx
SYNC
RECOG.
Tx
PACKET
HANDLER
FIFO
(+SR)
SPI
NSS
SCK
MOSI
MISO
Potential datapaths (data operation mode dependant)
Figure 24. SX1231 Data Processing Conceptual View
The SX1231 implements several data operation modes, each with their own data path through the data processing section.
Depending on the data operation mode selected, some control blocks are active whilst others remain disabled.
5.1.2. Data Operation Modes
The SX1231 has two different data operation modes selectable by the user:
?
?
Continuous mode: each bit transmitted or received is accessed in real time at the DIO2/DATA pin. This mode may be
used if adequate external signal processing is available.
Packet mode (recommended): user only provides/retrieves payload bytes to/from the FIFO. The packet is automatically
built with preamble, Sync word, and optional AES, CRC, and DC-free encoding schemes The reverse operation is
performed in reception. The uC processing overhead is hence significantly reduced compared to Continuous mode.
Depending on the optional features activated (CRC, AES, etc) the maximum payload length is limited to FIFO size, 255
bytes or unlimited.
Each of these data operation modes is described fully in the following sections.
Rev. 7 - June 2013
Page 45
www.semtech.com
相关PDF资料
SX1701BI085TRT IC AMP 2.5GHZ 5.3V 16-MLPQ
TA002-10002 LED HEATSINK W/FAN 12V 40X10MM
TC620HEPA IC TEMP SNSR 5V DUAL TRIP 8-DIP
TC623CVOA713 IC TEMP SNSR 3V DUAL TRIP 8-SOIC
TC624VOA IC TEMP SNSR PROG 2.7V 8SOIC
TC6501P125VCTTRG IC TEMP SWTCH OPEN DRAIN SOT23A5
TCS3104FN IC COLOR SENSOR LIGHT-VOLT 4-DFN
相关代理商/技术参数
SX1231H 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Power Integrated UHF Transceiver with On-Chip 20dBm PA
SX1231HIMLTRT 制造商:SEMTECH 功能描述:290MHz- 1GHz RF Transceiver
SX1231IMLTRT 制造商:Semtech Corporation 功能描述: 制造商:Semtech Corporation 功能描述:RF Transceiver FSK/GFSK/GMSK/MSK/OOK 3.3V 24-Pin QFN EP T/R 制造商:Semtech Corporation 功能描述:IC 433/868/915MHZ TXRX 24-QFN 制造商:Semtech Corporation 功能描述:SX Series 290 to 1020 MHz 300 Kbps Low Power Integrated UHF Transceiver - QFN-24 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1, Frequency Min:433MHz, Frequency Max:915MHz, Modulation Type:FS 制造商:Semtech Corporation 功能描述:290MHz- 1GHz RF Transceiver
SX1231ITSTRT 制造商:Semtech Corporation 功能描述:LOW-POWER INTG UHF TRANSCEIVER
SX1231J 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Power Integrated UHF Transceiver with On-Chip 20dBm PA
SX1231JIMLTRT 制造商:Semtech Corporation 功能描述:UHF TRANSCEIVER FOR ARIB
SX1231SKB433 制造商:Semtech Corporation 功能描述:
SX1231SKB915 制造商:Semtech Corporation 功能描述:USB KIT - SX1231 915MHZ 制造商:Semtech Corporation 功能描述:development kit